vw-4th-immo-MQB-key-programming

The 2018 VW Passat in this post is equipped with immo 4 + MQB system, if need to add key, the key need to be special, ID46 chip can’t be copied by key copier. Below are the steps to program this car using Autel MK808TS.

Autel-MK808TS-program-vw-passat-immo-4-MQB-key

Step 1: Connect Autel MK808TS with car via OBD port, choose car model “VW”, then select: advanced mode > immo 4 + MQB key

Step 2: Select “key learning”, will prompt message “This function is available on a pay-per-use basis.  Continue or not? Choose “yes” to continue, then pay 10USD for this function, after making payment, the system will start to read and calculate immo data.

Step 3: Immo data calculation complete, click “yes” to continue to make dealer key.

Step 4: As per prompt, to generate the dealer key, need to read the original car key data. Please put the original car key into the programmer keyhole, and click “enter” to read the original car key data.

Step 5: Read original key data successfully, then put a new key need to be programmed into programmer keyhole, and select “enter”.

Step 6: Select “yes” to lock the key, make the dealer key success.

Step 7: program next key. Click “No” to enter key learning procedure.

Step 8: Put the first key on the car's induction coil, wait for 2 seconds and click "enter". (Note: If other keys are too close to the coil, key learning may fail.)

Step 9: Put the last key on the car's induction coil, wait 2 seconds and click "enter". (Note: If other keys are too close to the coil, key learning may fail.)

Step 10: Key learning complete.

Step 11: Start the car ok, the key remote function is automatic activated. Finish.

 

DISCLAIMER: The technology and software in the blog are only used for technical research and auto repair, and are not allowed to be used for illegal purposes, We will not be responsable for any direct and indirect damages from the use of the file created by this page.