In last post, we discussed programming 2014 Toyota Yaris all key lost, 2014 Vios also use 8A chip, the method of reset smart box 93C86 is same, but the steering lock 93C46 is same as Camry 2014. Check below details:
Step 1: Reset Steering lock (immo) data.
Disassemble the steering lock from the car, then open the lock No. 45020-0D-04 and find the EEPROM chip 93C46, read the chip with key programmer such as Yanhua key master, vvdi prog and CG100 etc. Save the data and backup. Modify the data like this: retain the first and second bytes with blue underline of row 020, usually shown 5555, Other bytes all replace with F, save the file and write the file back to EEPROM chip. Assemble the steering lock to car.
Step 2: Reset smart box.
Disassemble smart box NO. 625606-000 which placed on the right side behind the passenger’s glove box, open and find the EEPROM chip 93C86, read the chip with key programmer, save file and backup, start modify the data like this: Retain the red area, replace the bytes with blue underline with 0, remaining bytes all replace with F. Refer below photo of Toyota Yaris.
Step 3: Learn the key. With steering lock and smart box assemble back to car, go to car and push start button, the dash will be lighted meaning everything going well. Connect key programmer with car OBD, select Toyota smart system, following the steps, make the smart key logo held close to start button, comes with “beep beep”, that is the indication of adding key successful.
Step 4: Do the synchronization process. Connect 4th pin and 13th of OBD with cable or paper clip, push start button, many lights in dash panel will start flashing, wait for 45 minutes, then push stop button and remove the cable. Finish. Start the car.
DISCLAIMER: The technology and software in the blog are only used for technical research and auto repair, and are not allowed to be used for illegal purposes, We will not be responsable for any direct and indirect damages from the use of the file created by this page.