land-rover-discovery-add-key

Tested ok to use TMPro 2 to do Land Rover Discovery 3 all key lost programming, below are detailed steps:

Step 1: Disassemble CEM

The car is all key lost, first open the door with tool, disassemble CEM which located behind glove box from passenger’s seat, open the CEM case to obtain electronic board

how-to-program-discovery-3-key

Step 2: Read data with TMPro 2

TMPro 2 software module 181 is for land Rover / Range Rover CEM, buy this module then we can read and program PIC18F6620 with TMPro 2. Download connection diagram, connect electronic board as per diagram to read data and save.

landrover-discovery-3-key-programming

land-rover-all-key-lost-programming

 

Step 3: Write key with TMPro 2

Prepare new PCF7936 transponder chip, load the data in step 2, insert 7936 chip to TMPRO key programmer, and then write key.

code-land-rover-discovery-3

Step 4: check encrypted chip

After generating chip, need to check it is encrypted, use KD-X2, vvdi key tool, Mini900 or handy bay to test. If encrypted, prove write key in step 3 is successful. With written chip installed in key, ready to start car.

 

DISCLAIMER: The technology and software in the blog are only used for technical research and auto repair, and are not allowed to be used for illegal purposes, We will not be responsable for any direct and indirect damages from the use of the file created by this page.